So I saw these today:

http://www.diamondsbylauren.com/index.ph...ight-half-moons

Would these look ok with a 9x7mm asha oval?

Are they tall enough to satisfy you when they are set on the side of the Oval? I have seen rings done both ways with the half moons smaller or with the half moons that are almost the same measurement as the "flat" edge they are going against. Does that make sense? Which is more pleasing to you visually? ~Red

I would be replicating this look:

http://www.pricescope.com/forum/show-me-the-ring/ready-or-not-t54834.html

Too small or just right?

I am certainly no expert but I think the half moons might be a tad too small. Hopefully one of the ladies with more experience will chime in soon. What a neat ring Lorrissey I hope it turns out just like you plan. ~Red

Those are too small. You would need something more like 6mm in length to get the look of the PS ring.

did you see that someone is selling a VERY similar ring? Just smaller?

Not to make things hard....

Where? Send me the link, please.

http://www.pricescope.com/forum/preloved...st-t179064.html

I think it's in the $3400 range?